Bay 12 Games Forum

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Digging 1x1 pit  (Read 1040 times)

roryk

  • Escaped Lunatic
    • View Profile
Digging 1x1 pit
« on: August 30, 2011, 09:14:13 pm »

How do I dig a 1x1 pit? I only seem to be able to dig a 'channel' which dwarves and other things can just walk into and out of. Any ideas?

Thanks!
Logged

Sphalerite

  • Bay Watcher
    • View Profile
    • Drew's Robots and stuff
Re: Digging 1x1 pit
« Reply #1 on: August 30, 2011, 09:17:39 pm »

Dig a tunnel underground.  Wall off a 1x1 space at the end of the tunnel.  Channel out the ground over that 1x1 space.
Logged
Any intelligent fool can make things bigger and more complex... It takes a touch of genius --- and a lot of courage to move in the opposite direction.

wrajjt

  • Bay Watcher
    • View Profile
Re: Digging 1x1 pit
« Reply #2 on: August 30, 2011, 09:34:41 pm »

How do I dig a 1x1 pit? I only seem to be able to dig a 'channel' which dwarves and other things can just walk into and out of. Any ideas?

Thanks!

Use "dig up ramp" on the floor below. Hopefully you're not digging too far, and your miner wont go asleep/decide he's too hungry or thirsty to finish the work. Since he will be stuck down there until he's done, I mean. If the pit is supposed to be 1x1x1, then you can use channel and then use DFhack to remove the upramp, and you'll have a pit with vertical walls.
Logged

Forumite

  • Bay Watcher
    • View Profile
Re: Digging 1x1 pit
« Reply #3 on: August 31, 2011, 06:16:17 am »

ramp down, then two more squares so itīs tunnel-tunnel-ramp. Channel from above so the left tunnel is breached from above. Build a wall in the middle, making sure your mason isnīt trapped. Floor the original ramp from above. The result should be something like this, surface and the Z-level below on different lines:

Open space - natural floor - constructed floor
Empty square - constructed wall - ramp without access to surface
Logged
"The ability to quote is a serviceable substitute for wit." - W. Somerset Maugham

Brackev

  • Bay Watcher
    • View Profile
Re: Digging 1x1 pit
« Reply #4 on: August 31, 2011, 10:14:50 am »

I usually go at least 2 wide.  Stairs on one side, pit on the other.  After I'm done digging, wall over the top stairs
Logged
-------

Dinos with hammers, there is no escape.

BigD145

  • Bay Watcher
    • View Profile
Re: Digging 1x1 pit
« Reply #5 on: August 31, 2011, 11:28:18 am »

Channel.
Use dfhack to remove ramp.
Done.
Logged