Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Incantatar]

Yes, same problem. You can circumvent the error with ALT-K (Keys mode).

[SpudGunMcGee]

Also same issue



Any ideas? I did notice that \DWARFF~1\ seemed a bit out of place since that's not the right directory

[kayach]

Create \macros folder and it will work.

[LordBaal]

Dunno if has been asked before, but you do think about implementing designation priorities at some point? It would help a great deal.

[Encrtia]

How do walls work?

I typed in each cell "Cw" as per the sketchy manual I found at joelpt, but all it does is select the wall - then proceed to max it out to the 10x10 square without building anything.

So it follows the plan, but unable to place any walls. What am I missing?

[LordBaal]

How do walls work?

I typed in each cell "Cw" as per the sketchy manual I found at joelpt, but all it does is select the wall - then proceed to max it out to the 10x10 square without building anything.

So it follows the plan, but unable to place any walls. What am I missing?

You need to select the materials I think.

[Encrtia]

But... how?

Edit: I think I know the problem. It worked fine when there was no existing walls, but I'm trying to build it over already existing walls - ergo, it's stalling on those. Was trying to use it as an "auto-fill" for underground rooms that were partially destroyed from mining ores/gems.. *sighs* Doesn't work that way.

[Zwaryczuk]

Been playing DF for a while. Finally decided to automate some of my constructions. Downloaded quickfort and it works just fine for small builds but consistently misses designations or puts segments in the wrong place. My PC's power is not the problem as it was built with DF performance in mind and runs any game I've tried. Can anyone help please?

[Cthulhu Inc]

I am trying to use a #build template and encountered two errors.

Firstly, when using a multi-sheet xlsx file, it could not read it ("Error in qfconvert: could not read xlsx file")

I then exported each sheet to a .csv file. However, it thinks they are #dig templates, when I have #build in the first cell.