T2 'Breaker' Tank
Built from the ground up with RHA and a new 1.8-inch cannon about 6-7 feet long set in the turret as the primary gun along with a stallion on the cupola pintle mount for AA and two brumbies, one in the hull and one coaxial, as MG firepower, the breaker is in all ways intended to replace the old smasher. More heavily armed and armoured than it's predecessor, along with being faster and mounting a model 3 radio system. The biggest difference in the tank is the use of a five-man crew, one loader, one gunner, one commander, one driver and one radio operator/hull gunner.
+1
If we get good rolls
+1
+1
Your engineers set to work on a tank. A tank to be impervious to fire! A tank to break the lines! A tank to take back the desert! A tank to to bring glory to Moskurg! A tank to be
feared!T2 Breaker: A tank built from new Rolled Homogenous Armor, like tanks
should be made of. It is medium armored throughout, with a slanted front but mostly square. The turret is specially cast as a rounded dome. Includes a new 1.6 inch rifled Breaker cannon, with a long barrel, suspension and muzzle brake. The Breaker cannon can fire about 24 times a minute, it is single loaded by hand. It also has a coaxially mounted Brumby. The exit hatch in towards the mach of the tank and includes a pintle-mounted Brumby. The tank is a heavy, it sits on wide cowled treads and is powered by a big 12-cylinder engine, and can get up to about 25 mph. Crewed by a driver, loader, gunner, and commander. The radio is usually omitted due to the already very steep cost of the tank: It requires 5 ore, 3 oil.
This new tank is a pretty kickass piece of engineering, it's heavier, faster and better armed and armored than your previous tank. However, cost is going to be an issue...